Which Side Is Liner Side On Iron On Vinyl

Adjust your machine settings according to the iron on kiss cut guide below a kiss cut goes through the iron on film and leaves the liner intact.

Which side is liner side on iron on vinyl.

The adhesive side will be up. Iron on vinyl has a shiny side and a dull side. Be sure to thoroughly pay attention to the size of the iron on vinyl sheet or roll that you are ordering. The iron on vinyl is put onto the roll carrier side out which means the side that curls down is the carrier side and the side that curls up is the vinyl side in the end if you re faced with two shiny sides the same color the slightly less shiny side is going to be the vinyl side.

It is also worth mentioning that heat transfer vinyl is not sticky to the touch. Clearly the easy way to figure it out would be to try to pull the liner off from the vinyl and see which side has the sticky to it. Thus the dull side would be the liner side. Place the easypress onto the surface you will be applying the iron on to for about 5 seconds.

You can see the vinyl side up in this photo of heat transfer vinyl on a standard grip cutting mat. Cut on iron on vinyl setting. This tutorial walks you through the basics of using iron on vinyl of any type. Iron on vinyl from other places may arrive as a sheet.

With cotton it was 340 degrees right between the recommended temperatures for glitter and lite iron on. So again that s shiny side down. Then position it plastic side down and vinyl side up the more dull less shiny side. Take your weeding tool and scrape dig in the corner of the sheet.

Place your material with the liner pretty side up and press for 50 seconds using firm pressure. Place the shiny side down on your mat. This means that the good side is down. If you look carefully at iron on vinyl there is a liner side and a vinyl side.

Place iron on sheet shiny liner side down onto standardgrip mat. If you can get your tool under a layer of vinyl and pull it back then that s the side you should be cutting. The liner side should be the one placed down on the mat. Place the iron on vinyl on the cricut standard grip cutting mat liner side down.

Select and size the image s you want to cut. Pick a side of the sheet that you suspect might be the cut side e g the white side of the sheet of red htv. If this isn t heat transfer vinyl then i would assume that the shiny side is the top side or the side that is going to be showing. Be sure to mirror all images prior to cutting.

There is a layer of plastic that will be peeled away. The shiny side is the liner and the dull side is the heat activated side that you will.